

The G3SG1 | The Executioner in Battle-Scarred (BS) has a float here of 0.45 to 0.85. The 0.85 figure is the ceiling of the whole skin, so the band is cut off at the top. The skin is Classified rank, from the Revolver Case Collection. It drops from the Revolver Case and exists in four wears, from Minimal Wear to Battle-Scarred.
What the G3SG1 | The Executioner looks like in Battle-Scarred
A chipped orange-red layer lies over oxidized green metal, and pale bones run across the top. On the surface the paint is orange-red, worn down to patches. Under it is a gray-green and turquoise oxidized surface with blue and lilac streaks. The bones are pale yellow, cream, and the barrel, bipod, levers and scope lens are dark.
The red lies in patches on the receiver, the stock, the bracket and the scope rings, and in places reaches onto the barrel. On the forend there is almost no red: there it is a green base with a row of curved light ribs. On the magazine, crossed bones lie over the green, and a large cream bone runs along the top of the receiver toward the stock. No lettering can be made out.
In Battle-Scarred the red layer is stripped from every protruding part: the receiver edges, the forend edge, the butt heel, the scope rings. Further in, it recedes in patches and bares the green base. The cream bones hold longer on the flat surfaces, while the dark barrel and bipod hide wear.
What to check before buying
On the G3SG1 | The Executioner, look at these things before paying:
- the float within the band from 0.45 to 0.85;
- the stickers and name tag the G3SG1 | The Executioner got from a previous owner.
The pattern on the G3SG1 | The Executioner does not vary, so the pattern plays no part in the choice. It is worth searching for the G3SG1 | The Executioner by the number, not by the wear label: the 0.45 to 0.85 band is wide.
What the G3SG1 | The Executioner costs in Battle-Scarred
All the other wears are dearer. Minimal Wear is seven times dearer, Field-Tested noticeably, and Well-Worn slightly.
Among Classified G3SG1 skins, this one in this wear is at the top of the row. The nearest neighbor on price, Flux, is slightly cheaper.
Getting the G3SG1 | The Executioner
The skin drops from the Revolver Case. The Revolver Case Collection came out in December 2015, and the skin has been in the set since its release.
The G3SG1 | The Executioner can also be obtained by contract: ten skins one rank lower, the same collection.
StatTrak and Souvenir
The G3SG1 | The Executioner has a StatTrak version. There are no Souvenir packages with this skin.
Stickers and craft on the G3SG1 | The Executioner
The paint here is ragged, and a sticker almost always lands on patches of red, green and cream at once. Light stickers read on the dark barrel, the bipod and the green base, while red ones merge into the orange layer.
The wear of a copy is set at the drop and does not change afterward, so the stripped edges on a listing will stay exactly as they are.
Who this wear suits
Buying the G3SG1 | The Executioner in Battle-Scarred makes sense when:
- you want a rifle with stripped paint and the green base showing through;
- the cheapest variant of the skin matters, while the bones on the magazine and receiver still need to read;
- the choice is made by float within the wide band of 0.45 to 0.85.
Wear does not change how the G3SG1 shoots in CS2: it affects only the look.






























